Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 412

Software user interface
9.6 ML Keypad
Example for changing motor frequency parameters:
1. Press [SHIFT] [⇒] to get to the parameter ID display.
Enter parameter ID for motor frequency (1020).
Figure 9-69
2. Press the [ENTER] key once to show the motor frequency display and then press [ENTER]
again to edit its value.
Figure 9-70
The range of the variable is 15 to 330.
If, for example, you attempt to enter 010 for the motor frequency an error message will be
displayed for approximately four seconds.
Then the value shown before the attempted edit is displayed again.
M o t o r f r e q u e n c y
Figure 9-71
Summary of Operation Mode Displays
The following tables list the possible operational mode displays of line 1 and 2 of the display in
order of precedence.
Table 9-12 Line 1 of mode display
Order Code Meaning
1 FRST Fault reset
2 TLIM Menu setting rollback
3 SPHS Single phasing rollback
4 UVLT Undervoltage rollback
410
S p e e d P a r a m e t e r
E n t e r P a r a m I D 1 0 2 0
Status display after pressing [SHIFT] [⇒] and entering ID 1020
M o t o r f r e q u e n c y
( e d i t ) 0 1 0 . 0
Status display after pressing [ENTER] twice
O U T O F R A N G E
Status display upon entering a value beyond the range of the system
H z
Description
Displayed after the [FAULT RESET] button is pressed.
Note: This may not be visible because of the speed of response to a fault
reset.
Drive is being limited by a menu setting.
A single phasing condition of the input line is limiting drive torque.
A undervoltage condition of the input line is limiting the drive torque.
NXGPro+ Control Manual
Operating Manual, A5E50491925A