Removing The Projection Lens; Connecting To Ac Power - Christie Boxer 30 Installation And Setup Manual

1. Select MENU > Configuration > Lens Settings > Lens Calibration.
2. Select Enter.

Removing the projection lens

Use the correct method of removing the lens.
1. Push in and hold the lens release button.
2. Turn the lens counterclockwise until the lens guides are aligned.
3. Slide the lens straight out of the projector.
If the lens does not slide out easily, reset the lens offset before removing the lens.
4. Attach the lens cap to avoid damage.
Warning! If not avoided, the following could result in death or serious injury.
•
•

Connecting to AC power

The Boxer 30 projectors can operate in full or limited power modes, depending on the available or
required AC power source.
Power mode
Input 1: Full power
Input 2: Limited power
Boxer 30 (Bb.2) Installation and Setup Guide
020-102017-08 Rev. 1 (02-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Once the lens removal has begun the safety retention features of the lens are defeated.
To re-engage the safety lock mechanism, the lens must be removed and re-inserted, or
fully rotated clockwise until a click is heard.
Packaging tape is required to ensure safe shipment of the projection lens to restrain the
zoom ring from rotating during shipping.
Functionality
• Six lamp mode
• 30 amp rated connector
• 200 - 240 VAC
• Full brightness
• Single lamp mode
• 15 amp rated connector
• 100 - 130 VAC; 200 - 240 VAC
• Less brightness
Installation and setup
22