Introduction; Safety And Warning Guidelines - Christie Roadie D4K40-RGB Installation And Setup Manual

Introduction

This manual is intended for professionally trained operators of Christie high-brightness projection
systems.
The illustrations in this document are for representation only and may not depict your projector model
exactly.
Only Christie qualified technicians who are knowledgeable about the hazards associated with laser use,
high-voltage, and the high temperatures generated by the projector lasers are authorized to
assemble, install, and service the projector.
For complete D4K40-RGB product documentation and technical support, go to
www.christiedigital.com.

Safety and warning guidelines

Read all safety and warning guidelines before installing or operating the projector.
This projector is intended for use in a non-cinema environment.
This projector must be operated in an environment that meets the operating range specification. Use
only the attachments and/or accessories recommended by Christie. Use of others may result in the
risk of fire, shock, or personal injury.
Warning! If not avoided, the following could result in death or serious injury.
• This product must be operated in an environment that meets the operating range as specified in
this document.
• Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
• EXTREME BRIGHTNESS! When accessing a restricted access location for product service or
maintenance, avoid exposure to the product beam path by turning the product power off and
disconnecting the product from AC power, or by shuttering the light source to avoid emissions
from the front aperture.
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated
light beam of the projector.
• Keep fingers and other body parts away from the moving parts in the product. Tie back long
hair, and remove jewelry and loose clothing before manually adjusting the product.
• FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
• Do not operate the product without a lens installed.
• Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
• RADIATION HAZARD! Use of controls or adjustments, or performing procedures other than those
specified may result in hazardous radiation exposure.
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
6