Projector Components - Christie Roadie D4K40-RGB Installation And Setup Manual

Projector components

Identify the main components of the projector.
ID Component
A Front IR
B Projection lens
C Mounting and rigging
holes
D Display panel
E Keypad interface
F Christie TAP
G Tool box
H Communication and
input panel
I Rear IR
J LED and shutter LED
status indicator
K Power cord retainer
clamp
L Adjustable feet
M AC input
N Breaker switch
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Receives transmissions from the IR remote.
A variety of lenses can be used with the projector. Available lenses are listed in the
D4K40-RGB Specifications Guide (P/N: 020-102959-XX)
M12 x 1.75 holes for projector feet installation and for mounting and rigging points.
Four holes located on the top, and four located on the bottom.
Displays the projector menus and status.
Controls the projector.
Enables Android devices to communicate with the projector using near field
communication.
Provides tools for Christie qualified technicians.
Connects media sources to either the ports on the option cards or the IMXB
Receives transmissions from the IR remote.
Indicates power status and shutter status.
For stabilizing and protecting the power cord.
Raise or lower these feet when positioning the projector. Make sure the projector is
level on all sides and the displayed image appears rectangular without any keystone.
For use with projector power cord.
Circuit breaker switch to shut off AC power.
Installation and setup
17