Base I/O Unit Input/Output Specifications - Mitsubishi Electric MELDAS 600 Series Connection Manual

5.2.4 Base I/O Unit Input/Output Specifications

(1) Rotary switch (SW1, SW2) settings
Refer to Chapter 6 for the base I/O unit rotary switch (SW1, SW2) settings.
Reference item: 6.14 Setting of channel No. when using multiple remote I/O units
Normal setting
(2) RIO1, RIO2 terminator
Connect a terminator to the final end of the remote I/O unit connected to RIO1 and RIO2.
Terminator type: R-TM
(3) CF31, CF32 input circuit
Refer to Chapter 6 for the base I/O unit CF31 and CF32 input circuits.
Reference item: 6.4 Outline of digital signal input circuit
1 Unit name
2 Card name
3 Input type
4 COM pin connection +24V/GND
5 No. of input points
6 Pin used for input
(4) CF33, CF34 output circuit
Refer to Chapter 6 for the base I/O unit CF33 and CF34 output circuits.
Reference item: 6.5 Outline of digital signal output circuit
1 Unit name
2 Card name
3 Output type
4 Output current
5 No. of output points
6 Pin used for output
CHAPTER 5 CONNECTION OF I/O INTERFACE
5.2 Connection of Base I/O Unit
SW1 0
SW2 1
FCU6-DX210
HR325
Sink/source
48 points
X0~X2F
FCU6-DX210
HR325
Sink type
60mA/point
48 points
Y0~Y2F
The base I/O unit occupies two channels.
FCU6-DX211 FCU6-DX220
HR335 HR327
Sink/source Sink/source
+24V/GND +24V/GND
48 points 64 points
X0~X2F X0~X3F
FCU6-DX211 FCU6-DX220
HR335 HR327
Source type Sink type
60mA/point 60mA/point
48 points 64 points
Y0~Y2F Y0~Y3F
53
FCU6-DX221
HR337
Sink/source
+24V/GND
64 points
X0~X3F
FCU6-DX221
HR337
Source type
60mA/point
64 points
Y0~Y3F