Appendix 3 Emc Installation Guidelines; Introduction - Mitsubishi Electric MELDAS 600 Series Connection Manual

APPENDIX 3 EMC INSTALLATION GUIDELINES

This section is an excerpt of the "EMC Installation Guidelines BNP-B2230". Only the
pages related to the M600 Series are given.
Refer to the "EMC Installation Guidelines [BNP-B8582-45]" for details on the drive
section (servo amplifier/spindle amplifier).

1. Introduction

EMC Instructions became mandatory as of January 1, 1996. The subject products must have a CE mark
attached indicating that the product complies with the Instructions.
As the NC unit is a component designed to control machine tools, it is believed that it is not a direct EMC
Instruction subject. However, we would like to introduce the following measure plans to back up EMC
Instruction compliance of the machine tool as the NC unit is a major component of the machine tools.
(1) Methods of installation in control/operation panel
(2) Methods of wiring cables to outside of panel
(3) Introduction of members for measures
Mitsubishi is carrying out tests to confirm the compliance to the EMC Instructions under the environment
described in this manual. However, the level of the noise will differ according to the equipment type and
layout, control panel structure and wiring lead-in, etc. Thus, we ask that the final noise level be
confirmed by the machine manufacturer.
This section corresponds to the following Series.
MELDAS 600 Series
Matters related to the EMC measures in this manual have a priority over the details given in the
Connection Manual.
APPENDIX 3 EMC INSTALLATION GUIDELINES
1. Introduction
118