Storage - Vessel IPC20-E Instruction Manual

Maintenance
How to Clean the Electrode Wire
Clean the electrode wire about every 100 hours of use. To prevent electrical shock accidents, be sure
to unplug the power cord from the outlet and wait at least 1 min before cleaning the electrode wires.
Insert a cotton swab into the clearance on the finger guard to clean the electrode wire. If the electrode
is heavily contaminated, clean it with a cotton swab with a little alcohol and remove the stuck dirt. Do
not rub the electrode wire hard for cleaning. Failure to do so can result in a bent wire. Wipe it lightly.
How to Replace the Electrode Wire
Do not replace the electrode wire with a new one by yourself. Contact the store where the product was
purchased.
Static Erasing Capacity Check
Measure ion balance and charge voltage dampening time using a charge plate monitor.
Reference: IEC61340-5-1・2, ANSI EOS/ ESD S3.1
Adjustment
Because ions are generated with AC output, the SDJ-08S does not have an adjustment feature of ion
balancing. If ion balance is not good, contact the store where the product was purchased.
Cleaning the Case
Use a well-wrung, soft cloth soaked with water to clean the case. Do not use cleaners or other
substances containing surface-active agents as these could have a negative impact on the static
electricity erasing performance.

Storage

Storage
Prohibited
Do not store the IPC20-E in the below environments.
・Adverse environments can result in explosion, fire, electric shock and
accident.
・ Where explosion-proofing is required, where found flammable
atmospheres
・ Where excessive vibration or shock is applied to the eraser.
・ Where temperature and humidity are outside specified ranges.
・ Where dewing or sharp temperature fluctuations occurs.
・ Where there is heavy dust or smoke, where possibly wet by water, oil,
chemicals, etc.
・ Where strong electric or magnetic fields are generated.
CAUTION
32