Installation - Vessel IPC20-E Instruction Manual

Installation

Installation Area
Prohibited
Remember
Remember
Installation Area
Install the unit in an indoor location not subject to wind, rain, or direct sunlight.
Avoid using the unit in areas where water, oil, or condensation will get on it or where it will be
subject to sudden temperature changes.
Avoid using the unit where it will be subject to strong vibration or impacts.
An exhaust outlet is provided on the rear of this unit, so placing the rear of the unit close to the
wall will prevent normal exhausting and decrease the dust collecting capability. Install the unit
with its back at least 10 cm from the wall.
Ambient temperature and humidity
Use in a temperature range of 0°C to +40°C. Use the unit in a humidity range of 20 to 80%.
Atmosphere
Do not operate the unit in environments where anti-explosion measures are required.
Do not operate the unit in areas where corrosive gases or flammable or explosive gases are
used. In addition, use the unit in a well ventilated area with a normal air atmosphere.
Input voltage and compressed air
This unit uses AC 230V (50/60 Hz) input voltage and 0.4 MPa to 0.7 MPa compressed air for the
cleaning air. Install the unit where it can be connected to wiring and piping that meet these
specifications.
Maintenance space
Space for maintenance and inspections should be maintained around the unit.
In particular, the space in front of the unit required for daily maintenance should be obtained.
Do not use this product in the following areas. Where there is a risk of an
explosion or fire.
･ Environments that require anti-explosion measures.
･ Areas where corrosive gases or flammable or explosive gases are used.
Take into consideration the conditions surrounding the installation area.
･ Install the unit in an indoor location not subject to wind, rain, or direct
sunlight.
･ Where possibly wet by water, oil, chemicals, etc.
･ Where excessive vibration or shock is applied to the unit.
･ Use in a temperature range of 0°C to +40°C. Use the unit in a humidity
range of 20 to 80%.
Do not use this product where it will be directly exposed to high temperatures
or high humidity. Doing so could cause the motor to burn out or breakdown.
WARNING
CAUTION
14