Vessel IPC20-E Instruction Manual page 43

Installation Method
When installing this unit, place it on a level, strong, and smooth, flat bench.
Remember
Remember
CAUTION
Electrical power wiring
Remember
Remember
Remember
Remember
Check the specifications
Checks to make sure the specifications of the supplied power make the unit's power
specifications.
Wiring circuit breaker
Use a wiring circuit breaker to prevent overloading. It is also recommended that a ground-fault
interrupter be installed.
WARNING
To keep the unit from falling over, do not climb on the working surface or
place heavy objects on it.
When installing the IPC20-E, place it on a level, strong, and smooth, flat
bench.
It can be damaged and malfunction if it falls.
Check the following, being aware of the weight of the product.
･ Be sufficiently careful that no part of the body, especially fingers and toes,
will be caught underneath the product while it is being installed or moved.
･ Make sure the product does not fall over while it is being installed or
moved.
･ Do not move the product while an object is set on its hood. The object
could fall off of the hood.
WARNING
Use IPC20-E only with 230V AC. Use of other voltage may result in fire and
electric shock.
To prevent electrical shock accidents, be sure to unplug the power cord from
the outlet before performing any wiring.
To prevent electrical leaks, electrical shock, and fire accidents perform the
wiring work in accordance with electrical equipment technology standards
and in-house wiring provisions.
Make sure the switch is turned to ( 〇) when plugging the power cord into
the outlet.
15
Installation