Type 2A (With Chthd1/Thchd1 T-Harness) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 2a (with CHTHD1/THCHD1 T-Harness)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
OR
See page 8 for
wiring information
(-) Driver Door Trigger
driver door (Jeeps ONLY)
12-pin Connector
Ignition
Barrel
(vehicle side)
See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
[1]
Wires not listed in this diagram are not required for the installation.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Twisted pair in the steering column or behind radio
FT CAN High: Orange/Green: 5
FT CAN Low: Orange/Brown: 6
(-) Parking Lights: Green/Black: 2
[1]
Parking Light MUX Output: Violet/Green: 8
[1]
Parking Light MUX Output: Violet/Brown: 9
[1]
RAP Off: Yellow/Black: 10
Violet wire in
driver kick panel or
CHTHD1/
THCHD1
(optional)
(harness side)
White/Orange
White/Gray, White,
White/Pink or White/Black
RF
DBALL2
Prog. Button
LED
12-pin Connector
12-pin Connector
(harness side)
(Vehicle side)
Rev.: 20160908
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
(+) 12V
RX
(-) Ground
TX
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.
Page 6