Type 2B (Without T-Harness) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 2b (without T-Harness)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
OR
See page 8 for
wiring information
Ignition
6
Barrel
12
Ignition Switch
(connector side view)
See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
[1]
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Twisted pair in the steering column or behind radio
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
FT CAN High: Orange/Green: 5
FT CAN Low: Orange/Brown: 6
(+) 12V: Brown: 7
(+) Ignition Car Side: Yellow: 8
(+) Ignition Key Side: Orange/Yellow: 9
(+) 12V: Red: 13
(-) Ground: Black: 14
(-) Parking Lights: Green/Black: 2
[1]
Parking Light Out.: Violet/Green: 8
[1]
Parking Light Out.: Violet/Brown: 9
[1]
RAP Off: Yellow/Black: 10
(-) Driver Door Trigger
Violet wire in
driver kick panel
or
driver door(Jeeps ONLY)
1
7
White/Orange
White/Gray, White
or White/Pink
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
Rev.: 20160908
Page 7
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
(+) 12V
RX
(-) Ground
TX
© 2016 Directed. All rights reserved.