Type 3A (With Chthd2/Thchd2 T-Harness R9) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 3a (with CHTHD2/THCHD2 T-Harness R9-R10)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
See page 12 for
wiring information
To vehicle's
(+) Parking Lights
85
86
87
87a
30
+12V
Fuse 15A
Ignition Switch
(Vehicle side)
8-pin Connector
(harness side)
Wires not listed in this diagram are not required for the installation.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Diagnostic Connector OBDII
(connector side view)
HS CAN High: pin 6
1 8
9 16
HS CAN Low: pin 14
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(-) Parking Lights: Green/Black: 2
RAP Off: Yellow/Black: 10
(-) Driver Door Trigger
Violet wire in
driver kick panel
CHTHD2/
THCHD2 R9-R10
(optional)
N.C.
Use this connection ONLY
with DBALL2.
However, it must NOT be
used in the Nitro, Liberty,
Wrangler & Wrangler
Limited.
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
8-pin Connector
8-pin Connector
at ignition switch
(harness side)
(Vehicle side)
Rev.: 20160908
Page 9
Hood Pin
White/Black
Remote Start Safety
Override Switch
(+) 12V
RX
(-) Ground
TX
© 2016 Directed. All rights reserved.