Type 4 (Not Compatible With T-Harness) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 4
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
(+) Parking Lights
To vehicle's
(+) Parking Lights
See page 15 for
wiring information.
86 85
87
87a
30
+12V
Fuse 15A
5-pin
or
6-pin
1 1
(-) Ground:
Ignition Switch
Black or
(connector side view) Black/Striped,
Refer to the Vehicle
Wiring Reference
Charts on page 15
for Start wire colors
and location.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Use this connection
ONLY with DBALL2.
Diagnostic Connector OBDII
(connector side view)
1
9
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(-) Parking Lights: Green/Black: 2
Multiplex Output: Violet/Green: 8
Multiplex Output: Violet/Brown: 9
Sentry Key Module
near Ignition Switch
8
(connector side view)
(+) 12V: Red or
Red/Striped, pin 5
pin 4
HS CAN High: pin 6
8
16
HS CAN Low: pin 14
FT CAN High: Tan/Black: 3
FT CAN Low: Tan: 4
(+) 12V: Brown: 7
(+) Ignition: Yellow: 8
(+) Start: Yellow/Red: 11
(+) 12V: Brown/Red: 12
(+) 12V: Red: 13
(-) Ground: Black: 14
RF
Prog. Button
LED
Rev.: 20160908
Page 14
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
DBALL2
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.