Type 3B (With Chthd2/Thchd2 T-Harness R1-R6) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 3b (with CHTHD2/THCHD2 T-Harness R1-R6)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
Also note that this installation is NOT compatible with DBALL2.
See page 12 for
wiring information
To vehicle's
(-) Driver Door Trigger
(+) Parking Lights
85
86
87
87a
30
+12V
Fuse 15A
Ignition Switch
(Vehicle side)
8-pin Connector
(harness side)
Wires not listed in this diagram are not required for the installation.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
(-) Parking Lights: Green/Black: 2
RAP Off: Yellow/Black: 10
Violet wire in
driver kick panel
CHTHD2/
THCHD2 R1-R6
(optional)
RF
DBALL2
Prog. Button
LED
8-pin Connector
at ignition switch
(Vehicle side)
8-pin Connector
(harness side)
Rev.: 20160908
Page 10
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
(+) 12V
RX
(-) Ground
TX
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.