Type 1B (Without T-Harness) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 1b (without T-Harness)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
To vehicle's
(+) Parking Lights
White/Violet
85
86
87
87a
30
+12V
Fuse 15A
ONLY connect for
Dodge Journey.
OR
See page 5 for
wiring information
6
Connector side view
at ignition switch
12
See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
[1]
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
(+) 12V: Brown: 7
Ignition Isolation (veh. side): Yellow: 8
Ignition Isolation (conn. side): Orange/Yellow: 9
(+) 12V: Red: 13
(-) Ground: Black: 14
(-) Parking Lights via Relay: Green/Black: 2
[1]
Parking Lights MUX Output: Violet/Green: 8
[1]
Parking Lights MUX Output: Violet/Brown: 9
[1]
RAP Off: Yellow/Black: 10
(-) Driver door Trigger
Violet wire in
driver kick panel
Ignition
Barrel
1
7
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.
Rev.: 20160908
Page 4
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
(+) 12V
RX
(-) Ground
TX