Type 3C (Without T-Harness) - Directed Xpresskit DBALL2 Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 3c (without T-Harness)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
See page 12 for
wiring information
To vehicle's
(+) Parking Lights
85
86
87
87a
30
+12V
Fuse 15A
(-) Driver Door Trigger
Violet wire in
driver kick panel
1
Connector
(+) 12V: Red or
at Sentry Key Module
Red/Striped,pin 5
near Ignition Switch
(-) Ground: Black or
Black/Striped, pin 4
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Diagnostic Connector OBDII
(connector side view)
HS CAN High: pin 6
1 8
9 16
HS CAN Low: pin 14
FT CAN High: Tan/Black: 3
FT CAN Low: Tan: 4
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(+) 12V: Brown: 7
(+) Ignition: Yellow: 8
(+) 12V: Red: 13
(-) Ground: Black: 14
Multiplex Output: Violet/Green: 8
Multiplex Output: Violet/Brown: 9
(-) Parking Lights: Green/Black: 2
RAP Off: Yellow/Black: 10
Refer to the Vehicle
Wiring Reference
Charts on page 13
for CAN wire colors
and location.
8
Use this connection ONLY
with DBALL2.
However, it must NOT be
used in the Nitro, Liberty,
Wrangler & Wrangler
Limited.
RF
DBALL2
Prog. Button
LED
Rev.: 20160908
Page 11
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
(+) 12V
RX
(-) Ground
TX
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.