Checking Ground Resistance At The Optical/Tributary Shelf Power Input - Fujitsu FLASHWAVE 7500 Installation Manual

CHAPTER 2
Core Configuration

Checking Ground Resistance at the Optical/Tributary Shelf Power Input

2.12 Checking Ground Resistance at the Optical/Tributary
Shelf Power Input
Ideally, frame ground and battery return at the shelf power input connectors are common to
each other. Essentially a resistance of 0 ohms should be present between them and little or no
voltage potential across frame ground and battery return.
The test equipment required is a DMM or a voltmeter and ohmmeter that can accurately
detect low resistance levels. See
*% *$
Step Task
Use the DMM set to the voltmeter function or a voltmeter to measure the voltage between
1
frame ground and each of the battery return points. The reading should be very close to 0 V
DC.
2 Does the voltage exceed 1 V DC?
If YES:
Do not continue with
technical assistance, call 1-800-USE-FTAC (800-873-3822).
If NO:
Continue with
FLASHWAVE 7500 Release 6.1
2-58
Equipment Installation
Revision 1, June 2009
Figure 2-32 [p.
)* 0$,1 % 0$,1 $
Figure 2-32: Ground Voltage Check Example
Step 3 [p. 2-59] until the voltage source has been eliminated. For
Step 3 [p. 2-59].
Fujitsu and Fujitsu Customer Use Only
2-58].
'00
92/76
'&
$03
FNC-7500-0061-200
Issue 1, May 2009