Installing Fans, Rack Covers, And End Panels; Installing Shelf Fans - Fujitsu FLASHWAVE 7500 Installation Manual

CHAPTER 4
ETSI Configuration

Installing Fans, Rack Covers, and End Panels

4.12 Installing Fans, Rack Covers, and End Panels
This procedure provides instructions for installing the Optical/Tributary shelf fans, optional
rack covers, and end panels.
N .
O
4.12.1
4.12.2
4.12.3
4.12.1

Installing Shelf Fans

This procedure provides installation instructions for the four cooling fans used by the
Optical/Tributary shelf (see
Step Task
1 If not already done, unpack four fan plug-in units from the shipping container.
2 If not already done, install a fan filter in the fan tray located at the bottom of each fan unit.
Install the fan plug-in units into the bottom portion of each Optical/Tributary shelf. (Refer to
3
Maintenance and Trouble Clearing, Section 8.8, Replacing FAN6 Plug-In Unit and Fan Filter
[p. 8-28]
This procedure is complete.
Note: The connectors on the back of the fan engage the shelf backplane connectors and are secured
in place with an extractor lever (located on the left side of the fan assembly front panel).
FLASHWAVE 7500 Release 6.1
4-42
Equipment Installation
Revision 1, June 2009
It includes the following subprocedures:
S
UBPROCEDURE
Installing Shelf Fans . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing Rack Covers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing Aisle End Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 4-24 [p.
FAIL/SVCE
Figure 4-24: Fan Unit (Front View)
(ETSI Configuration)
for detailed information.)
Fujitsu and Fujitsu Customer Use Only
4-42]).
FC9682FAN6
FAN6
Iss. 01
e u r e d o c P r
P
AGE
4-42
4-43
4-60
FNC-7500-0061-200
Issue 1, May 2009