Installing The Circuit Breaker Panel Or Fuse Panel - Fujitsu FLASHWAVE 7500 Installation Manual

3.6

Installing the Circuit Breaker Panel or Fuse Panel

The circuit breaker panel (CBP) (see
follows) should be the first item installed in the rack. For procedures to install the CBP, refer
to Circuit Breaker
other equipment can be installed.
Note: Fujitsu does not manufacture a 19-inch CBP. For 19-inch rack applications, Fujitsu
recommends using the N215116-N/L31 fuse panel manufactured by Noran Tel Ltd. Refer to
Noran Tel documentation for installation instructions for the N215116-N/L31 fuse panel. This
unit can be ordered through Fujitsu using part number 06-331-444.
Note: The CBP may not have circuit breakers CB1 through CB4 installed. Locate the
HA15B-0001-C365 circuit breaker kit, if required, for labels and circuit breaker units.
FNC-7500-0061-200
Issue 1, May 2009
Revision 1, June 2009
Figure 3-17 [p.
Panel. After the CBP or fuse panel is installed at the top of the rack, the
Figure 3-17: Circuit Breaker Panel, HA15B-001-B361
Fujitsu and Fujitsu Customer Use Only
Small Configuration
Installing the Circuit Breaker Panel or Fuse Panel
3-29]) or fuse panel (see the note that
FLASHWAVE 7500 Release 6.1
Equipment Installation
CHAPTER 3
3-29