Fujitsu FLASHWAVE 7500 Installation Manual page 346

CHAPTER 5
Extension Configuration
Installing Power, Ground, and Alarm Cables
39 Using wire-wrap connections, connect the free wire ends of the rack alarm cable harness
(HA660-1106-T003) to the wire-wrap pins on the CBP rear panel or local office alarm
facilities. Refer to
Breaker
Secure the rack alarm cable to the interior of the rack so that the cable connectors (CNA
40
through CNF) face the rear of the shelves.
Note: Rack alarm cable connectors (CNA through CNF) have identical pinouts to the office alarm
cable described in
Install Shelf Alarm Cables
41 Within the rack cabling schematic (identified in
cables (HA660-1102-T015) that connect shelves to the rack alarm cable harness
(HA660-1106-T003). One shelf alarm cable is required for each shelf.
Figure 5-18 [p. 5-34]
Extension shelf backplane.
42 For each shelf in the rack, connect both ends of shelf alarm cable (HA660-1102-T015) as
follows:
a. Connect one end of the cable to the appropriate connector (CNA through CNF) of the
rack alarm cable harness (HA660-1106-T003), as indicated in rack cabling schematic.
b. Connect the other end of the cable to the office alarm port on the shelf backplane as
shown in
Repeat
43
Final Checks
Dress and lace all cables, and secure to the rack interior using standard local procedures.
44
Using local procedures, reconnect the battery office power that was removed from the rack, or
45
reinstall the circuit breakers.
This procedure is complete.
FLASHWAVE 7500 Release 6.1
5-42
Equipment Installation
Revision 1, June 2009
Cable and Wiring
Panel, for CBP alarm block details.
Section 5.13.6 [p.
shows how the shelf alarm cable (HA660-1102-T015) connects to an
Figure 5-18 [p. 5-34]
Step 42 [p. 5-42] for each shelf in the rack.
Fujitsu and Fujitsu Customer Use Only
Guide, for wire-wrap, color-code details and
5-55].
Step 2 [p. 5-36]) identify the shelf alarm
(Extension shelf ).
Circuit
FNC-7500-0061-200
Issue 1, May 2009