Installing Aisle End Panels - Fujitsu FLASHWAVE 7500 Installation Manual

CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
4.12.3

Installing Aisle End Panels

This procedure provides instructions for installing the end panel on ETSI racks (see
Figure 4-43 [p.
Note: This panel is intended to prevent accidental removal of cards and fiber and is for an ETSI
only application.
Step Task
If not already done, remove the end panel and mounting hardware from the shipping
1
container.
Install the M5 screws and washers at the top of the rack, leaving approximately 1/8 inch to
2
allow the notch in the end panel to slip between the washer and the frame. See
[p. 4-61].
3 Position the end panel over the M5 screws installed in
until the screws are seated in the slots at the top of the frame.
4 Attach the bottom of the panel to the frame with M6 screws and washers.
5 Attach the cover panel with 8-32 screws.
This procedure is complete.
FLASHWAVE 7500 Release 6.1
4-60
Equipment Installation
Revision 1, June 2009
4-61]).
Fujitsu and Fujitsu Customer Use Only
Figure 4-43
Step 2 [p. 4-60], and lower the panel
FNC-7500-0061-200
Issue 1, May 2009