Fujitsu FLASHWAVE 7500 Installation Manual page 381

8 Was the module installed in a muxponder unit?
If YES:
Continue with
If NO:
Proceed to Step 10 [p.
For a muxponder plug-in unit, close the stainless steel client connection drawer (see
9
Figure 6-8 [p.
the muxponder plug-in unit.
For a Flexponder plug-in unit, lower the hinged door to cover the front of the plug-in unit, if
10
present.
Note: Older versions of the IFMA-BUC1 unit have the hinged door. Newer versions of the IFMA-BUC1
unit do not have a hinged door. The IFMA-BXC1 unit does not have a hinged door.
This procedure is complete.
FNC-7500-0061-200
Issue 1, May 2009
Revision 1, June 2009
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing SFP Modules in a Muxponder or Flexponder™ Unit
Step 9 [p. 6-19].
6-19].
6-14]), and gently tighten the two thumb screws that secure it on the front of
Fujitsu and Fujitsu Customer Use Only
CHAPTER 6
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-19