Fujitsu FLASHWAVE 7500 Installation Manual page 65

8 On the backplane of the shelf identified in
shelf power terminal strip located on the bottom right of the shelf backplane (see
[p. 2-44]).
Connect both ends of cable GA of the power harness as follows:
9
a. Identify lug GA in the power harness (see
terminal GA (see
b. Connect the other end of the same cable to CBP terminal RTN A1 CB1 (see
Figure 2-25 [p.
Connect both ends of cable GB of the power harness as follows:
10
a. Identify lug GB in the power harness (see
terminal GB (see
b. Connect the other end of the same cable to CBP terminal RTN B1 CB1 (see
Figure 2-25 [p.
Connect both ends of cable MA of the power harness as follows:
11
a. Identify lug MA in the power harness (see
terminal MAIN A (see
b. Connect the other end of the same cable to CBP terminal BATT A1 CB1 (see
Figure 2-25 [p.
Connect both ends of cable MB of the power harness as follows:
12
a. Identify lug MB in the power harness (see
terminal MAIN B (see
b. Connect the other end of the same cable to CBP terminal BATT B1 CB1 (see
Figure 2-25 [p.
Connect both ends of cable FGND of the power harness as follows:
13
a. Identify lug FGND in the power harness (see
shelf terminal FG (see
b. Connect the other end of the same cable to the equipment rack frame ground.
14 Replace the plastic cover over the shelf backplane terminal strip.
FNC-7500-0061-200
Issue 1, May 2009
Revision 1, June 2009
Step 5 [p.
Figure 2-27 [p. 2-44]).
2-42]).
Figure 2-27 [p. 2-44]).
2-42]).
Figure 2-27 [p. 2-44]).
2-42]).
Figure 2-27 [p. 2-44]).
2-42]).
Figure 2-27 [p. 2-44]).
Fujitsu and Fujitsu Customer Use Only
Core Configuration
Installing Power, Ground, and Alarm Cables
2-48], remove the plastic cover on the
Figure 2-21 [p. 2-38]) and connect it to shelf
Figure 2-21 [p. 2-38]) and connect it to shelf
Figure 2-21 [p. 2-38]) and connect it to shelf
Figure 2-21 [p. 2-38]) and connect it to shelf
Figure 2-21 [p. 2-38]) and connect it to
FLASHWAVE 7500 Release 6.1
Equipment Installation
CHAPTER 2
Figure 2-27
2-49