Installing An Oracle Zfs Storage Zs4-4 Or Oracle Zfs Storage Zs3-4 Controller Onto The Rack Slide Rails - Oracle ZFS Storage DE3-24P Installation Manual

Installing an Oracle ZFS Storage ZS4-4 or Oracle ZFS Storage ZS3-4 Controller onto the Rack Slide Rails

Optional: If installing the assembly with cage nuts and mounting screws, insert the cage
3.
nuts into the front and rear rack posts in the desired positions. Then insert the mounting
screws through the front and rear slide-rail brackets and rack posts.
Repeat steps 2 and 3 for the other slide-rail assembly.
4.
Installing an Oracle ZFS Storage ZS4-4 or Oracle ZFS Storage
ZS3-4 Controller onto the Rack Slide Rails
Use the following procedure to install an Oracle ZFS Storage ZS4-4 or Oracle ZFS Storage
ZS3-4 controller onto the rack slide rails.
Caution:
This procedure requires a minimum of two people, or a mechanical lift, because of
the weight of the chassis. Attempting this procedure alone could result in equipment
damage or personal injury. Always load the heaviest equipment (disk shelves) at
the bottom of the rack.
If your rack includes an anti-tip foot, extend it from the bottom of the rack.
1.
Note:
The slide rails can be used with either 9.5-mm square or M6 round mounting
hole racks.
Chapter 8
8-3