Table of Contents
Advertisement
Lower the rack stabilization feet if you have not already done so.
2.
Pull the slide rails (mounted in the slide-rail assembly) toward you until the slide rails stop
3.
(approximately 12 inches (30 cm) out of the rack).
Raise the chassis so that the back ends of the mounting brackets are aligned with the
4.
slide rail and insert the chassis into the slide rails, pushing the chassis slowly, until the
mounting brackets meet the slide rail stops (approximately 12 inches (30 cm) out of the
rack). You will hear an audible click.
The following graphic illustrates the chassis insertion and slide rail locks usage.
5.
Installing an Oracle ZFS Storage ZS5-2 Cable Management
Arm
Use the following procedure to install the cable management arm (CMA) on an Oracle ZFS
Storage ZS5-2 controller.
The CMA is an optional assembly that you can use to route the controller cables in the rack.
This procedure is completed from the back of the rack.
Before You Begin
Unpack the CMA and identify its components.
To prepare for installing the cable management arm (CMA), follow these guidelines:
Installing an Oracle ZFS Storage ZS5-2 Cable Management Arm
Chapter 7
7-5
Hide quick links:
Advertisement
Table of Contents
