Interfaces
Interface types
If you reset your ScanPlus to its factory default settings (
parameters ), no interface type is selected (null interface). In this case, you will have to re-
enter the appropriate interface number for your system (
Identifying the interface
The Part Number (P/N) indicates the hardware interface setup for your ScanPlus model.
The number of green indicator LED flashes at power-up indicates the interface driver
selected for your ScanPlus. If you have an energy saver pushbutton model and the
pushbutton is activated, you will have to press the pushbutton to see the power-up flashes.
P/N identification
factory default setting
(all models)
x - x x x x x 0 - x x - x x
x - x x x x x 1 - x x - x x
x - x x x x x 2 - x x - x x
x - x x x x x 3 - x x - x x
x - x x x x x 4 - x x - x x
x - x x x x x 5 - x x - x x
x - x x x x x 7 - x x - x x
SP/XX/RM/10/E/960401
IBM 46xx cash registers
Laser emulation
Keyboard wedge
OCIA cash registers
RS-232
Wand emulation
selected interface type
null interface
laser emulation
wand emulation
RS-232 C
IBM 46xx cash registers
RS-232 TTL
OCIA cash registers
keyboard wedge
Interfaces
Reset all configuration
Compose interface number ).
green LED indication
continuous LED
no LED
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
7 flashes
53