Beeps / green indicator LED
Beeps / green indicator LED
Power-up beeps / power-up LED
Two beeps indicate that the power-up sequence has been completed.
Three long beeps followed by five short beeps indicate an EEPROM integrity error at power-
up. If this occurs, contact your UBI representative.
If you have an energy saver pushbutton model and the pushbutton is activated, the
power-up beeps and power-up LED are deactivated and can not be activated.
Power-Up Beeps Power-Up LED On (*)
Identifying the interface
After the two power-up beeps, the number of green indicator LED flashes at power-up
indicates the interface driver selected for your ScanPlus.
The Part Number (P/N) indicates the hardware interface setup for your ScanPlus model.
green LED indication
continuous LED
no LED
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
7 flashes
14
Power-Up Beeps Power-Up LED Off
selected interface type
null interface
laser emulation
wand emulation
RS-232 C
IBM 46xx cash registers
RS-232 TTL
OCIA cash registers
keyboard wedge
P/N identification
factory default setting
(all models)
x - x x x x x 0 - x x - x x
x - x x x x x 1 - x x - x x
x - x x x x x 2 - x x - x x
x - x x x x x 3 - x x - x x
x - x x x x x 4 - x x - x x
x - x x x x x 5 - x x - x x
x - x x x x x 7 - x x - x x
SP/XX/RM/10/E/960401