Time-Out Between Different Consecutive Codes - UBI ScanPlus 1800 Reference Manual

Time-out between different consecutive codes

By default, you can read two different codes immediately one after the other—there is no
time-out between reads.
Compose timeout between different consecutive codes
Increasing the timeout before you can read a different code protects against unwanted
reading of other bar codes if they are close together on the same label.
This time-out should not be longer than the Timeout Between Identical Consecutive
Codes.
Example To make your ScanPlus wait 1 second (= 1000 ms) before it can read a
different code:
1. Scan Compose Timeout Between Different Consecutive Codes.
2. Scan 1 0 0 0 then scan End Selection (
SP/XX/RM/10/E/960401
Data decoding security parameters
No Time-Out Between Different Consecutive Codes (*)
Compose Timeout Between Different Consecutive Codes
(maximum time-out = 2550 ms)
inside back cover of this manual).
Number codes or
37