Table of Contents
Advertisement
Flashing mode
To increase LED life, the ScanPlus is configured by default to flash after 10 minutes in
standby instead of producing a continuous beam. When you present a bar code, it will
return to a continuous beam.
Flashing mode is the default mode for all ScanPlus models but is not available when
the pushbutton of pushbutton models is activated.
Compose flash time-out
Example
To make your ScanPlus start to flash after 30 minutes of inactivity:
1. Scan Compose Time-Out Before Flash.
2. Scan 3 0 then scan End Selection (
SP/XX/RM/10/E/960401
Flash After 10 Minutes (*)
No Flash
Compose Time-Out Before Flash
(1-minute increments, max = 60 minutes)
back cover of this manual).
Flashing mode
Number codes or inside
43
Advertisement
Table of Contents
