Time-Out Between Identical Consecutive Codes - UBI ScanPlus 1800 Reference Manual

Data decoding security parameters

Time-out between identical consecutive codes

By default, you can only read identical consecutive codes after a time-out between reads of
300 ms.
Compose timeout between identical consecutive codes
Increasing the timeout before you can read another identical code protects against
unwanted reading of the same bar code.
This time-out should not be shorter than the Timeout Between Different Consecutive
Codes.
Example To make your ScanPlus wait 1 second (= 1000 ms) before it can read the
same code again:
1. Scan Compose Timeout Between Identical Consecutive Codes.
2. Scan 1 0 0 0 then scan End Selection (
36
300 ms Between Identical Consecutive Codes (*)
Compose Timeout Between Identical Consecutive Codes
(maximum time-out = 2550 ms)
inside back cover of this manual).
Number codes or
SP/XX/RM/10/E/960401