Setting Up The Printer; Description - Intermec EasyCoder F2 User Manual

Chapter 6

Setting Up the Printer

Description

36
The setup controls the printer in regard of serial communication,
media feed, and print speed, and specifi es which type of media
and (optionally) ribbon is loaded in the printer.
Check the list of the printer's default setup parameters on the next
page to see if they match your requirements. If not, you will have
to change the setup using one of the methods described below.
The setup may also be changed, manually or automatically, by
Intermec PrintSet, InterDriver, and LabelShop, or by third-party
application programs.
• Setup Mode
- Press the <Setup> key on the printer's built-in keyboard to
enter the Setup Mode, or
- select the Setup option in Intermec Shell to enter the Setup
Mode, or
- execute the Intermec Fingerprint SETUP instruction to
enter the Setup Mode, or
- access the Setup Mode via the printer's home page using an
optional EasyLAN 100i interface board.
See Chapter 7, "Setup Mode" in this manual and the documenta-
tion of the EasyLAN 100i interface board.
• Intermec Shell
- Use Terminal Setup option to change the setup remotely
from the host.
See Chapter 8, "Intermec Shell" in this manual.
• Intermec Fingerprint
- Use setup strings to change individual setup parameters
remotely from the host, or
- use setup fi les to create sets of setup parameters remotely
from the host.
See the Intermec Fingerprint v7.61 manuals.
• Intermec Direct Protocol
- Use setup strings to change individual setup parameters
remotely from the host.
See the Intermec Direct Protocol v7.xx manuals.
Intermec EasyCoder F2 – User's Guide