Memory Card - Intermec EasyCoder F2 User Manual

Memory Card

Intermec EasyCoder F2 – User's Guide
If you want to use a memory card, you must insert it into
the slot in the printer's rear plate before you switch on the
power. The memory card can be an SRAM card complying with
the JEIDA-4 standard or a Flash Memory card from Intermec.
Maximum size in both cases is 64Mbit (8MB). There are three
types of Flash Memory cards:
• Font Cards provide additional fonts that can be used as long as
the card remains inserted in the printer.
• Font Install Cards permanently install additional fonts in
the printer, which can be used even after the card has been
removed.
• Firmware Cards automatically replace the printer's fi rmware,
usually with an updated version.
Always switch off the power before inserting or removing a memory
card! The manufacturer's logotype should face right when viewing
the card as in the illustration above.
Chapter 3
Important!
Starting Up
Memory Card
19