Intermec EasyCoder F2 User Manual page 31

Peel-Off, cont.
7
Route the liner around the tear bar and the liner
drive roller and back under the print mechanism
and guide shaft.
9
Press the handle to expand the takeup hub and secure
the liner. Then rotate the hub counterclockwise until
the liner becomes tight.
Intermec EasyCoder F2 – User's Guide
8
Insert the start of the liner under the lip of the takeup
hub, then rotate the hub counterclockwise a few
turns to wind up some of the liner.
10
This diagram shows the media and liner paths.
Chapter 4 Media Load
29