Ribbon Break Shaft (Option) - Intermec EasyCoder F2 User Manual

Chapter 12 Adjustments

Ribbon Break Shaft (option)

Adjustment Screw
Ribbon Break Shaft
86
If ribbon wrinkling occurs, you may need to adjust the alignment
of the front ribbon break shaft so that it runs parallel to the print-
head and the ribbon supply and rewind hubs. The adjustment
is done using a straight-slot screw that is located immediately
behind the front ribbon break shaft.
• If the ribbon tends to slide outwards, turn the screw carefully
clockwise (fw) to move the outer end of the break shaft
forward.
• If the ribbon tends to slide inwards, turn the screw carefully
counterclockwise (bw) to move the outer end of the break
shaft backward.
Before readjusting the break shaft, make sure that there is no
other cause for the wrinkling of the ribbon. (See Chapter 10,
"Troubleshooting.")
Important!
Intermec EasyCoder F2 – User's Guide