Media Roll Supply Post; Chapter 2 Installation - Intermec EasyCoder F2 User Manual

Chapter 2 Installation
Media Compartment, cont.
Description, cont.
Media Supply Roll Post
Caution!
Make sure to adjust the posi-
tion of the post according to
the size of the media roll core.
When the post is fi tted in
the top position, the head of
the screw will interfere with
small (38 mm/1.5 inches)
cores, causing media misalign-
ment.
12
Because the EasyCoder F2 has a modular design, it uses a media
supply roll post that can be fi tted in three different positions
inside the media compartment. The position depends on the
type of side door (long or short) and whether or not the printer
is fi tted with an integral liner takeup. Alternatively, an external
media supply (for example a box of fan-folded tickets) behind the
printer can be used. A rotating media supply hub is also available
as an option, see Chapter 9, "Options."
The media supply roll post fi ts both 38-40 mm (1.5 inches) and
76 mm (3.0 inches) cores since it can be moved vertically in the
slot in center section. The bottom position is intended for small
cores and the top position is for large cores. The post is locked by
a straight-slot screw and has a moveable edge guide to fi t various
media widths.
To move the post to a different slot; remove the screw, twist the
post a quarter of a turn, and pull it out.
To fi t the post; rotate it a quarter of a turn, insert it into the
appropriate slot in the center section (see next page), and twist
back so the lips engage the cutouts in the sides of the slot. Move
it up (large core) or down (small core) as far as it goes and secure
it with the screw.
Intermec EasyCoder F2 – User's Guide
Edge Guide
Screw