Tear-Off (Straight-Through) With Quick-Load - Intermec EasyCoder F2 User Manual

Tear-Off with Quick-Load (Straight-through)
1
Remove any empty core from the media
supply roll post.
Intermec EasyCoder F2 – User's Guide
In addition to the media load procedure for tear-off (straight-
through) operation described earlier in this chapter, the
EasyCoder F2 can optionally be fi tted with a set of Quick-Load
guides that makes media load much easier and quicker, especially
if the printer has a short side door. See Chapter 12, "Adjust-
ments" for installation instructions.
Quick-Load cannot be combined with peel-off (self-strip) opera-
tion.
Use the <Feed> key (see fi gure #5) when loading the same type
of media. When switching to a new type of media, or if the
printer does not feed out the media properly, simultaneously
press the <Shift> and <Feed> keys to perform a "testfeed."
An optional label taken sensor can hold the printing of the next
copy in the batch until the present copy has been removed, see
Chapter 10, "Options."
Fully automatic loading, without the operator having to press any
key, requires a special set of Intermec Fingerprint instructions in the
application program.
2
post and adjust the edge guide so the roll
becomes fl ush with the center section.
Chapter 4
Fit a new roll of media on the supply
Media Load
25