Intermec EasyCoder F2 User Manual page 61

Setup Mode Overview, Part 5
(Intermec Fingerprint v7.61)
If an optional an EasyLAN 100i interface board is installed in the printer, additional menus will be displayed.
SETUP:
Standard Setup Mode
See Overview Part 1
SER-COM, UART1
SETUP:
NET-COM, NET1
Standard Setup Mode
SETUP:
See Overview Part 1
FEEDADJ
Standard Setup Mode
SETUP:
See Overview Part 2
MEDIA
SETUP:
Standard Setup Mode
PRINT DEFS See Overview Part 2
SETUP:
NETWORK
• Press <Setup> to exit the Setup Mode.
Intermec EasyCoder F2 – User's Guide
NET-COM,NET1:
NEW LINE
NETWORK:
IP SELECTION
NEW LINE:
CR/LF
LF
CR
IP SELECTION:
MANUAL
DHCP
BOOTP
RARP
NETWORK:
IP ADDRESS
NETWORK:
NETMASK
NETWORK:
DEFAULT ROUTER
Chapter 7 Setup Mode
Use <.> and <0> - <9>
IP ADDRESS:
to set IP address.
192.168.1.79
Use <C> to erase.
Use <.> and <0> - <9>
NETMASK:
to set netmask.
255.255.255.0
Use <C> to erase
Use <.> and <0> - <9>
DEFAULT ROUTER:
to set default router.
192.168.1.1
Use <C> to erase.
59