Intermec EasyCoder F2 User Manual page 59

Setup Mode Overview, Part 3
(Intermec Fingerprint v7.61)
If an optional Double Serial or Industrial Interface Board is installed in the printer, additional menus will be displayed
(in case of Double Serial Interface Board, also see Overview Part 4):
SETUP:
SER-COM,UART2
SETUP:
SER-COM,UART3
Intermec EasyCoder F2 – User's Guide
SER-COM,UART2:
BAUDRATE
SER-COM,UART2:
PROT ADDR
SER-COM,UART2:
CHAR LENGTH
SER-COM,UART2:
PARITY
SER-COM,UART2:
STOP BITS
SER-COM,UART2:
FLOWCONTROL
SER-COM,UART2:
NEW LINE
SER-COM,UART2:
REC BUF
SER-COM,UART2:
TRANS BUF
SER-COM,UART2:
CONNECTED HW
SER-COM,UART2:
PROTOCOL ADDR.
BAUDRATE:
9600
19200
38400
57600
300
600
1200
2400
4800
PROT ADDR:
DISABLE
ENABLE
CHAR LENGTH:
8
7
PARITY:
NONE
EVEN
ODD
MARK
SPACE
STOPBITS:
1
2
FLOWCONTROL:
RTS/CTS
FLOWCONTROL:
ENQ/ACK
FLOWCONTROL:
XON/XOFF
NEW LINE:
CR/LF
LF
CR
REC BUF:
[300]:
TRANS BUF:
[300]:
CONNECTED HW:
RS232
PROTOCOL ADDR.
[1]:
Chapter 7 Setup Mode
These menus are only displayed if RS 485 is selected on "uart2:"
These menus are not displayed if RS 485 is selected on "uart2:"
RTS/CTS flowcontrol cannot be
RTS/CTS:
selected for the following types of
DISABLE
hardware connection on "uart2:":
ENABLE
• 422 NON ISOLATED
• 422 ISOLATED
ENQ/ACK:
DISABLE
ENABLE
XON/XOFF:
DATA TO HOST
XON/XOFF:
DATA FROM HOST
The selected type of hardware connection on "uart2:"
is displayed as one of the following alternatives (read-only):
• RS232
• 422 NON ISOLATED
• 422 ISOLATED
• RS485
These menus are only displayed if RS 485 is selected on "uart2:"
Enter printer's protocol address (0–31).
DATA TO HOST:
DISABLE
ENABLE
DATA FROM HOST:
DISABLE
ENABLE
57