Otto Bock C-Leg 3C98-3 Instructions For Use Manual page 52

Appendices
Beep signal
30 x long
–
Error while charging the product
LED on LED on
power sup­ battery
ply charger
52
Vibration signal
1 x long, 1 x short
repeated every 3 seconds
Continuous
Error
Country-specific plug adapter not fully
engaged on power supply
Non-functional socket
Defective power supply
No connection between battery charger
and power supply
Defective battery charger
Battery is fully charged (or connection
with product is interrupted).
Result
Severe error/indication
of safety mode activa­
tion
e.g. one or more sensors
are not operational.
Total failure
Electronic control
longer possible. Safety
mode active or undeter­
mined valve state.
Undetermined product
behaviour.
Resolution
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Check
device.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Check whether the charging cable plug is
fully engaged on the battery charger.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Take note of the confirmation signal for
differentiation.
When the battery charger is connected or
disconnected, a self-test is conducted and
confirmed by a beep and vibration signal.
The battery is fully charged if this signal is
heard.
If no signal is emitted, the connection to
the product is interrupted.
If the connection to the product is inter­
rupted, an authorised Ottobock Service
Centre must inspect the product, battery
charger and power supply.
Required action
Walking possible with restric­
tions. Please note the possible
change in flexion/extension
resistance.
Attempt to reset this error by
connecting/disconnecting the
battery charger. The battery
charger must be connected for
at least 5 seconds before it is
disconnected.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Center.
Attempt to reset this error by
connecting/disconnecting the
no
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Center.
socket with another
C-Leg 3C98-3/3C88-3
electric