Adaptation Of The Seating Shell/Seating System; Installing A Seating Shell - Otto Bock Shape System (Option); Removing/Installing A Seat Plate (Option) - Otto Bock Discovery tmax Instructions For Use Manual

Hide thumbs Also See for Discovery tmax:

Table of Contents

Adjustments

+30° -5°

a) Angle adjustment in 10° increments

1) Loosen the upper Allen head screw on the back plate (see Fig. 8, item 1).

2) Loosen and remove the angle adjustment screw on the back plate (see Fig. 8, item 2).

3) Adjust the backrest to the desired angle with the help of the existing bores.

4) Tighten all Allen head screws to 10 Nm.

5) Proceed the same way on the other side.

b) Setting 5° interim angles

1) Loosen the front Allen head screw (see Fig. 9, item 1).

2) Loosen and remove the rear Allen head screw (see Fig. 9, item 2).

3) With installed lashing point: loosen 1 x Allen head screw/1 x anchor point (see Fig. 9, item 3).

4) Adjust the backrest angle by 5°. Use the available bore for this purpose.

5) Tighten all Allen head screws to 10 Nm.

6) Proceed the same way on the other side.

6.5 Adaptation of the Seating Shell/Seating System

6.5.1 Installing a Seating Shell – Otto Bock Shape System (Option)

This option may only be installed by Otto Bock at this time.

INFORMATION

The preinstalled seat plate can continue to be used within the approved adjustment range.

For removal/installation within the scope of adjustments or retrofitting a new seat plate, complete the following steps:

a) Removal/installation to adjust the width of the seat frame

1) Loosen all mounting screws (countersunk head screws) between the seat plate and seat plate supports (see

Fig. 10, item 1).

2) After adjusting the frame width, (see Page 10) position the seat plate:

→ The front of the seat plate is flush with the front of the lateral tubes of the seat frame (see Fig. 10, item 2).

→ The seat plate is centred between the lateral tubes of the seat frame.

5°

02/2012

Table of Contents