Mounting/Removing The Seating Shell/Seating System - Otto Bock DISCOVERY TMAX Instructions For Use Manual

Usage
→ The pins must not be able to be removed after the pushbutton has been released.
→ The pins must be in the same angle position on both sides.
23

6.3.1.4 Mounting/Removing the Seating Shell/Seating System

Seating systems on a seat plate
The seating shell/seating system is mounted on the wheelchair by qualified personnel according to the needs of the
user. Users or attendants are not supposed to remove or install the seating shell/seating system.
INFORMATION
► If you believe that removal is required (e.g. to transport the wheelchair), please contact the qualified person­
nel that adapted the product for you.
Seating systems with Mygo adapter
The Mygo (see Fig. 12) and KIT (not pictured) seating systems can be removed or attached to the Mygo adapter in
just a few steps.
Removing the seating system
1) Stand next to the seating unit and hold it by the backrest with one hand.
2) Open the seat lock underneath the seating unit. Do this by pulling the locking pin and twisting it by 90°, so that
it stays open (see Fig. 25).
3) Pull the release handle under the seating unit up (see Fig. 26).
4) Fold the seat back (see Fig. 27).
5) Pull the retaining claw of the seating shell support from the adapter tube (see Fig. 28).
→ The seat has been removed.
25
20 | Ottobock
24
26
discovery tmax