I Scan Resume Condition - Icom ID-1 Instruction Manual

11
SCAN OPERATION

I Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (pgs. 86, 87)
D D Setting from the application
q Display the Set Mode screen.
- Select "Edit Set Mode(C)..." in View menu.
- Click " " in tool bar.
- Press [F7] key on the PC keyboard.
wDouble click the "Scan Resume Timer" cell, then select the
desired scan resume condition from "P-2," "T-5," "T-10" and
"T-15."
89
[
Double click
then select the desired
scan resume condition.
• Resuming conditions
• "P-2" : Scan pauses until the signal disappears and then re-
sumes 2 sec. later.
• "T-5" : Scan pauses 5 sec. while receiving a signal.
• "T10" : Scan pauses 10 sec. while receiving a signal.
• "T-15" : Scan pauses 15 sec. while receiving a signal.
eTo close the Set Mode screen, click " " in tool bar or click
" . "
D D Setting from the RC-24
q Push [TXinh•
] for 0.5 sec. to enter set mode.
wPush [MODE] or [TXinh•
Timer" item.
• Select " " for "
[TXinh• ]
[MODE]
e Rotate [DIAL] to select the desired scan resume condition.
• See "•Resuming conditions" above.
r Push [PWR] momentarily to exit set mode.
] several times to select "Scan
" item in advance.