Icom ID-1 Instruction Manual page 76

9
DATA OPERATION
D D Setting from the RC-24
q Push [MODE] to select DD (Data) mode.
• " " appears.
w Set the desired frequency.
ePush [RP•4] several times to select "
ing the PC through repeater/s.
• " " displayed briefly.
rPush [CS•
•1] to enter call sign select mode, then rotate
[DIAL] to select the desired station call sign.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
For direct data transferring between ID-1s, go to step i i .
tPush [CS•
•1] one more time to select "
tate [DIAL] to select the desired near-by repeater call sign,
if desired.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
yPush [CS•
•1] one more time to select "
tate [DIAL] to select the gateway repeater call sign, if de-
sired.
uPush [
] for 0.5 sec. to enable the gateway connection,
when the repeater require the "G" setting.
• " " appears beside the call sign.
NOTE: When the near-by repeater is gateway repeater,
push [ ] for 0.5 sec. (if necessary) after the call sign set-
" in step t and skip step y.
ting into "
iPush [CS•
•1] once (or twice) to exit call sign select
mode.
69
o Push [TXinh•
• "
• Starts accessing to the desired PC (via repeater/s).
!0 Open "Network Computers."
," when connect-
• The shared folder of the desired station appears.
• It may takes a minutes until the shared folder appears according
to the conditions, or PC performance.
!1 O pen the shared folder, then drag and drop the desired file
to transferring.
!2 P ush [TXinh•
mission) from the gateway repeater.
," then ro-
," then ro-
] to release transmission inhibit.
" appears instead of " " indication.
] again to disconnect (inhibit the trans-