I Programming Scan Edge Channels - Icom ID-1 Instruction Manual

11
SCAN OPERATION

I Programming scan edge channels

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges PA and PB, in memory channels.
D D Programming from the application
— main screen
q Set the desired scan start frequency in VFO mode.
➥ Set the operating mode with [MODE]
➥ Set the frequency using [DIAL] or keypad.
➥ Set other data (e.g. station call sign, tone information,
etc.) if required.
w Click [MW] to display the Memory programming screen.
85
eSelect the memory channel "PA" by right clicking or left
clicking on the [DIAL] in the screen.
• Click to select "MEMORY" if call is selected.
Click to
select.
Shows the selected scan
edge channel and previously
programmed frequency.
rClick [MW] on the Memory programming screen to pro-
gram.
Click
tSet the desired scan end frequency in VFO mode as the
step q.
ySelect the memory channel "PB," then click [MW] in Mem-
ory programming screen to program.
uTo close the Memory programming screen, click [MW] on
the main screen again or click " . "
Select "PA" or "PB"
channel.
Click