I Copying A Memory Contents - Icom ID-1 Instruction Manual

10
MEMORY/CALL OPERATION

I Copying a memory contents

This function copies a memory channel's contents to VFO (or
another memory/call channel). This is useful when searching
for signals around a memory channel frequency and for re-
calling the offset frequency, subaudible tone frequency etc.
D D Copying from the application
— main screen
qSelect the desired memory/call channel to be copied with
[DIAL] or keypad.
• Click [V/M] or [CALL] to select memory or call channel, if necessary.
w Click [MW] to display the Memory programming screen.
eClick to select the desired mode (MEMORY, CALL or VFO)
to be copied to.
rSelect the desired memory or call channel number by right
clicking or left clicking on the [DIAL] in the screen.
Click to
select
Shows the selected memory
channel number and previ-
ously programmed frequency.
tClick [MW] on the Memory programming screen to copy.
yTo close the Memory programming screen, click [MW] on
the main screen again or click " . "
77
Right click to move memo-
ry channel number up.
Left click to move memory
channel number down.
D D Copying from the application
— Memory Channel screen
q Display the Memory channel screen.
- Select "Edit Memory Channel(M)..." in View menu.
- Click " " in tool bar.
- Press [F6] key on the PC keyboard.
wRight click any cell of the desired memory/call channel to
be copied, except "Select," then select "Copy(C)" from the
displayed menu as below.
• After selecting a cell of the desired memory channel, press [C]
key while [Ctrl] key is pressed and held— these key actions are
the same as the mouse operation above.
eRight click any cell of the desired memory/call channel to
be copied to, except "Select," then select "Paste(V)."
• After selecting a cell of the desired memory channel, press [V]
key while [Ctrl] key is pressed and held— these key actions are
the same as the mouse operation above.
NOTE: Copying a memory/call channel contents to VFO is
not possible from the Memory Channel screen.
Select to copy.
Select to paste.