Icom ID-1 Instruction Manual page 93

D D Programming from the application
— Memory Channel screen
q Display the Memory channel screen.
- Select "Edit Memory Channel(M)..." in View menu.
- Click " " in tool bar.
- Press [F6] key on the PC keyboard.
wClick to select the "Freq." cell of either the scan edge chan-
nel, PA or PB, then enter the desired operating frequency
from the PC keyboard directly.
eDouble click the Mode cell in the same memory/call chan-
nel, then select the desired operating mode.
Click to select, then enter
the desired scan edge
frequency.
Double click the
Mode cell, then
select the desired
operating mode.
r Set the other items as follows.
• Repeaters— RP
Double click the cell, then select the
desired duplex condition.
• Repeaters— Offset Freq.
Click to select the cell, then enter the desired offset fre-
quency from the PC keyboard directly.
• TONE/TSQL— Tone Select
Double click the cell, then select the
desired tone condition.
• TONE/TSQL— Repeater Tone, TSQL Tone
Double click the cell, then select the
desired tone frequency.
• Digital— DSQL
Double click the cell, then select the
desired digital squelch condition.
• Digital— Code
Click to select the cell, then enter the desired digital code
number from the PC keyboard directly.
11
SCAN OPERATION
11
86