Programming The Camera Daughterboard - KLS Martin group marLED E3 Service Manual

Service Manual
Operating Lights marLED® E3, E9, E9i, E15, battery and
marLED® E3 on ceiling tube Ø 110 mm
12.3.5

Programming the Camera Daughterboard

•
Remove the interface adapter from the control electronics board.
•
Connect the flat ribbon cable (2) of the interface adapter (1) to the camera daughterboard (3).
•
Set the right-hand switch (1) of the interface adapter to Program.
•
With the left-hand switch, select Master (2).
•
To perform the update (1), select the *.ehx program file under File, path
Software\ Zusatzplatine Kamera E-Serie\.
•
Make the settings shown under Programming Configuration.
•
Under Port, select the serial interface.
• Click the Program button (2).
•
This starts the updating process for the camera daughterboard.
Revision 2
131