12.3.3
Programming Master
•
Select "Master" (Fig. 12-2, 6) with the left-hand switch.
Start the C2Prog.exe program.
•
•
Under File, select the *.ehx file for updating the master.
•
Under Programming Configuration, make the settings shown.
•
Under Port, select the interface (2).
•
Click the command button Program (3).
•
This starts the master updating process.
•
Following completion of the master DSP updating process, click OK to close the window.
128
Operating Lights marLED® E3, E9, E9i, E15, battery and
marLED® E3 on ceiling tube Ø 110 mm
Service Manual
Revision 2