KLS Martin group marLED E3 Service Manual page 130

• Once the software update has been finished successfully, click OK to close the window.
•
Change the switch position Program (5) on the programming board to Run (7), see "Settings on
programming adapter", page 127.
• After programming, press the Reset button 2x.
•
Unplug the programming adapter and operate the power ON/OFF button of the light.
•
Turn on the light again to perform function test.
It is absolutely essential to press the Reset button 2x after programming.
130
Operating Lights marLED® E3, E9, E9i, E15, battery and
marLED® E3 on ceiling tube Ø 110 mm
Service Manual
Revision 2