Programming Slave - KLS Martin group marLED E3 Service Manual

Service Manual
Operating Lights marLED® E3, E9, E9i, E15, battery and
marLED® E3 on ceiling tube Ø 110 mm
12.3.4

Programming Slave

The program updating process for the slave DSP can be started immediately after updating the
master DSP, no reset required.
•
Select "Slave" (4, Fig. 12-2) with the left-hand switch.
• Under File, select the *.ehx file for updating the slave DSP.
•
Under Programming Configuration, make the settings shown.
•
Under Port, select the serial interface (2).
• Click the command button Program (3).
•
This starts the slave updating process.
Revision 2
129